Metal Separator
Metal Separator
For different Applications
The Suspended Electromagnet provides tramp metal collection from conveyed materials, is a widely used magnetic separator.
The electromagnet is typically mounted or suspended over a conveyor belt to remove large pieces of tramp metal that represent a hazard to downstream crushers, mills, pulverizers and grinders.
Features and Benefits
Exclusive oil expansion tank prevents condensation and protects against hot spots to extend coil life
Special options, including:
CSA approved designs for both manual and self cleaning units
Upgraded coil design for elevations greater than 3,000 feet above sea level
High fire point coolants
Zero speed switches
Dust covers
Pulley guards and controls
Permanent extensions and monitoring devices
Force-cooled units available for high temperature applications
New adjustable oil expansion tank design for any installation angle is mounted with slotted brackets, allowing the user to rotate the tank so the moisture drain is always on the low side
Lift lugs now include two side-by-side holes to allow for simultaneous hoisting and installation of the suspension gear
23 magnet sizes, 69 standard models and hundreds of special designs available for unique applications
Aluminum or copper coils use Nomex insulation and fiberglass spacers to prevent shorts
IMPROVE machine protection
Our separators use wire coils and direct current to provide a magnetic field which can be used to separate ferrous material from non ferrous products.
It feature an easy installation and minimal maintenance.
Technical Specifications
We provide two types of cleaning models:
Manual Cleaning Models: All Manual Cleaning (MC) SE-7000 series models are cleaned of accumulated tramp iron by turning off magnet power periodically. MC models are recommended when occasional pieces or small amounts of iron may contaminate material flow.
Self Cleaning Models: Self Cleaning (SC) SE-7000 series models provide completely automatic iron removal and can be installed in an “in-line” or “cross belt” position. Both SC models have a short belt conveyor built around the magnet to effect automatic removal of tramp iron from the magnet face. This system features a rubber conveyor belt, bearings, rugged but simple continuous channel frame, adjustable take-ups and shaft-mounted reducer with V-belt coupling to a TEFC motor.
Gallery
